Megasafe - Contact US

Auditcon® 2 Series - Model 252 &552

OPERATING INSTRUCTIONS

1) Power the lock by briskly turning the dial back and forth in both directions,

until simultaneous green and red light flashes on the display.

2) Position the dial to cover the red bar and enter your user I.D. (which can be

any combination from 01 to 05).

3) Immediately enter the (6) six-digit combination.

4) Turn dial to the right (clockwise) within (10) ten seconds to retract bolt, and open safe.

5) To close, shut door and turn dial left (counter clockwise) until red bar is covered, bolt should be closed.

***Please note that after entering the incorrect combination five times, you will be in penalty (locked out for 3 minutes). Each consecutive wrong try will result in additional 3 minute penalty per try.

***If you experience a penalty the best solution is to wait a few minutes (10) and then try to center the correct combination. If you continue to experience technical difficulties you can contact us at 1-800-345-6552.

CHANGING COMBINATION

1) Power lock by briskly turning dial back and forth in both directions.

2) Press enter key or (#) key.

3) Enter your user I.D.

4) Immediately enter the current combination (if first time user, use the factory combination 1-2-3-4-5-6).

5) Enter the new (6) six-digit combination. Enter the new combination again for verification.

***YOUR USER I.D. ALWAYS REMAINS THE SAME***